Return HomeJoin Us On FacebookOur YouTube ChannelJoin Us On LinkedInOur Photo Album On FlickrJoin Us On Twitter
Drain Master Plumbers
Our residential plumbing servicesOur commercial plumbing servicesWater and sewer line no digging pipe replacementsWet, damp or flooded basementsDrain and drainage servicesWater and sewer line no digging pipe replacement videos
  Magazine and Tips Blog
Home
Magazine Blog
Plumbing Tips
Stories
Press Releases
Contact Us
June 2013
 
 
 

Sewer Line Problems:
June 14th 2013

Determine where the sewer line is leaking. It's usually the spot that is oozing to the surface.

2) Insert an air hose inside the line past the point of the break and apply air pressure to empty the line of remaining water.

3) Find a water line hose one size smaller than the sewer water line. Insert it into the larger pipe and push it in, well past where the break is thought to be.

4) Keep pushing it into the pipe until the far end is submerged in water. You can tell by blowing into the smaller pipe and hearing bubbling.

5) In the space between the two pipes, inject an expanding urethane foam crack filler. The harder, less expanding type works best.

6) Hopefully, the urethane ran down to the water level, began to foam back up, sealed the crack, and you will see it oozing back out the top.

7) Clean up the excess foam, and wait for it to harden.

8) Connect the inner, smaller water line to the system and apply water pressure again.

Tips:

This method will not work unless the sewer line slopes downwards and away from you. You need the far end of the smaller, inner pipe to be submerged in water to prevent the foam from sealing the far end shut.
Vertical water lines work the best. Horizontal lines do not.

Attaching a long, narrow tube to the urethane foam applicator helps to inject the foam more easily into the gap between the inner and outer pipes.

Call our central office at: 604-739-2000 for a free quote on repairing your sewer or water lines, drain tiles or any other plumbing problems you have.

It's Still Raining In Vancouver:
June 1st 2013

Is your basement starting to get damp, wet or even flooded? It is possible your drain tiles that surround your house are damaged. If you want a dry basement, you must have an adequate foundation drainage system.

If your drain tiles have separated at the joint, been shattered, bent, cracked or lost its slope, water will start to get into your basement. We have the solution to get your basement dry again.

Drain Tiles can be in poor and deteriorated condition due to age of your home. Blockages, cracks or holes can be caused by debris in your drain tiles or even tree roots. tree roots.

Wet houses are linked to an increase in respiratory problems and the property value of your house may depreciate because the basement is prone to frequent flooding.

Vancouvers Best Plumber can replace your drain tiles and guarantee top quality workmanship. We are available 24 hours should an emergency arise. Give us a call at 604-739-2000

Staff at Vancouvers Best Plumber

Wet Basement | Flooded | Drain Tile | Sewer Line 


Burnaby Office: 3287 Ardingley Ave, Burnaby, BC, Canada, V5B 4A5 - Phone: 604-294-5300
Vancouver Area: Vancouver, BC, Canada, V5T 2B6 - Phone: 604-739-2000
North Vancouver: 559 East 4th Street, North Vancouver, V7L 1J7, BC, - Phone: 604-351-1668